Galaxy DX959

[RogerBaran]

Does anyone have the alignment procedures for the Galaxy DX959?

It seems that most sites are still keeping this radio a big secret!

Thanks!
Roger
_________________________
Uniden PC78XL
Galaxy DX959
General Washington
Cobra 25 NW

[msherren5]

http://www.dxzone.com/cgi-bin/dir/jump2.cgi?ID=8485 hope this helps mike

[bullwinkle]

become a paid member here and the service manual is downloadable.I just downloaded it and it gives the full alignment procedure. you will also need a freq counter and a scope to do it right. let me guess; the SSB transmitts off frequency? That was the problem with mine that I'm still working on. But yes; he has the manual in the members area right here!

[big mike 8113]

The SSB is also off freq. on mine, I was going to lighn it up before I installed it in my big truck, but found the tunning pot to be under a small PC board and unaccsesable for the tools I have so I saved that to take care of at a latter date. If any one knows of a trick to get to this Tunning point with out the dismantling of that small PC board I sure would appreiceate the help.
Thank's Big Mike 8113 Central Coast Calif.

[RedEye]

You can take the front panel off and get access to it easy... Remove the chrome bezel and knobs, then the front housing is held on by 2 screws on the sides. Remove them and the front will move forward allowing you to do adjustments without disconnecting anything....

[kc8mob]

I have this rig. It's been spot on since day one.

But you could use your clarifier, if it is made effective on xmit as well.
But I know this is not a split feature on this rig. rx.tx being controlled separately