TRC 449

onesolar · Post by **onesolar** » Wednesday 21st Feb 2007, 15:05

I'm looking to open the clarifier on my trc 449 but can seem to find the resister and diode to cut . Anyone have more info or a board layout?

Rick · Post by **Rick** » Thursday 22nd Feb 2007, 5:14

To make the clarifier work has a shift in RX and TX you need to unsolder R119 which is connected to D32, the end you need to unsolder is the other end known as the hot end when you have unsolder it connect the hot end to Pin 1 of IC6 and remove D30. That it all done.

Rick

onesolar · Post by **onesolar** » Thursday 22nd Feb 2007, 11:13

Can you tell me about where on the board to find the R 119?

Rick · Post by **Rick** » Thursday 22nd Feb 2007, 11:40

Sorry I do not know as it as been over 15 year?s sense I last work on one, but if you flow the wires from the clarifier control you will come across it. It is also connect to D30. You are looking for the Resistor end which is not connect to D30. Hope this helps.

Rick.

zodiac · Post by **zodiac** » Saturday 24th Feb 2007, 6:10

onesolar,
You have a PM. or it may be two.

Dave.

onesolar · Post by **onesolar** » Saturday 24th Feb 2007, 7:25

Ok I found the resister and diode .Now I'm looking for ic-6 ?I see the 858 is ic-7? Also can I just solder a wire with shrink tube to the hot end of r119?

Rick · Post by **Rick** » Saturday 24th Feb 2007, 8:09

IC6 is a small 3 pin voltage regulator. You need to lift the hot end of R119 and solder a wire to it and solder the other end to Pin 1 of IC6 and remember to remove D30. I would post you a diagram but we are having trouble trying to upload the forum, I have reported this problem to Scott (The Defpom) the guy which runs the forum.

If you have a email address I could send you a diagram, send your email address in a PM.

Rick.

onesolar · Post by **onesolar** » Saturday 24th Feb 2007, 9:39

The Defpom wrote:Here is a file which shows some of the diagram, as needed for this mod.

File? I don't see any attachment?

zodiac · Post by **zodiac** » Saturday 24th Feb 2007, 11:43

You have Email now with attachment.
Dave.

http://www.youtube.com/user/TheDefpom · Post by **The Defpom** » Saturday 24th Feb 2007, 13:21

OK, I think that I have the attachments working again, so here goes...

onesolar · Post by **onesolar** » Saturday 24th Feb 2007, 15:25

Thanks to all that helped. Clarifier works great.

captian_radio · Post by **captian_radio** » Wednesday 28th Feb 2007, 13:17

After doing this clarifier how much swing are you getting now. I did a 449 clarifier couple weeks ago but i got the voltage from a diode, cant remember which one and am getting 7 kc swing on the clarifier now and works fine
Bob

The Defpom Forum, for RadioMods, S&M Software and Music by The Defpom

TRC 449

TRC 449

Re: TRC 449 Clerifier mod

finding the componet

Re: TRC 449 Clerifier mod

TRC 449

location

Re: TRC 449 Clerifier mod.

Mail

trc-449

TRC 449 clarifier mod