Easyist and cheapist Way To Align a CB RIG

[Denstar51]

Can anyone tell me the poor man's way to do this with the least cash outlay?

[fatdude1]

take it to shop or send via ups or fedx that has all the proper equipment to do it

[zodiac]

Hi Dennis,
It would help if you told us what the radio is, then someone might have the answer your looking for .

Dave.

[Denstar51]

Sure, Dave, the radio is the hygain v with the PTBM036AOX board.

[onebuttuglygit]

hi ya matey....I too have been asking ths question ,,,,but have had no replies.....if you get one will you email or message me,,,,,and i`ll do the same .......
cheers
darren

[timrim]

The problem is, without proper equipment, you have little chance of aligning a radio. To completely align a radio, you need a wattmeter, signal generator, sinad meter, oscilloscope, frequency counter and a 50ohm non inductive dummy load at bare minimum.

You can do a basic power output alignment with just a good peak-reading wattmeter and dummyload, but thats gonna be about the limit as to what you can do.