The Defpom Forum, for RadioMods, S&M Software and Music by The Defpom

Wanting to do a irf520 mosfet mod. to this radio for the final and maybe the driver if this can be done. I was wondering if Rick or someone else may be able to give me any information on how to go about doing this.The radio is a uniden Washington board #pc-385ag and it has the mb8719 pll. Thanks in advace for any information and your help.

Can you read and understand Schematic Diagram?
As to do it in a stage-by-stage, method is a lot work for me which I do not have at the moment.
I can probably draw a diagram so time next week, but I will not guarantee to do so as I am very busy.

Yes i can read and understand schematics a little but i don't have one for this radio. Thank you for your time i know your a busy man. Many thanks to you and others who help out people like me trying to learn how to work on their own radios. Thanks again

Rick i would like to thank you again for the help on converting this radio over to a mosfet. I have received a lot of good compliments on this radio since this modification was done. Every one that i talk to says this radios modulation is louder and clearer than the galaxy saturn that i have been using that was set up nicely by a reputable CB shop. I guess it may be time to sell or trade the saturn. Thank you for sharing your knowledge it is greatly appreciated.

post it so the rest of us know thanks

yes please do post for others as well as reference.

Smokinjoe,
This is the output stage of the PC 385.

Hi Rick, hope your doing well. can you send me the info for this mod please. Thanks