The Defpom Forum, for RadioMods, S&M Software and Music by The Defpom

hi can anyone tell me how to change the n/b switch to set the rig up for zeros exp 27.560 it would be a lot better that using the kc jump switch regards philip

If you connect a wire from the centre of the KC shift and put it to a switch, then find a variable resistor of the same value as the KC shift control, put another wire from the switch to the variable resistor and the other side of the variable to 0 v (GND).
Now adjust the variable resistor for the zero.
If you want to use the NB switch, just hard wire and insulate the wires that are on the switch then you can use it for zero switching.

This should help you .