TC9109 and MB8733 PLL Frequency Synthesizer
Overview
This 27 MHz band, PLL frequency synthesizer LSI chip is designed specifically for CB transceivers.
The integrated circuit`s incorporates PLL circuitry and a controller for CB applications on a single CMOS chip.
This PLL-circuit use a 8 bit ROM programmable divide-by-N counter. The ROM-table is programmed from factory to 40 channels.
Pin | Name | Description |
1 | Vcc | Positive Supply Voltage |
2 | RI | Referency Oscillator Input |
3 | CL | |
4 | LD | Loop Detect - Unlocked=LOW Locked=HIGH |
5 | PD | Phase Detector Output |
6 | AI | Amp. Input |
7 | AO | Amp. Output |
8 | T/R | Transmit=HIGH Receive=LOW |
9 | F in | VCO Frequency Input |
10 | P0 | Programmable input 0 |
11 | P1 | Programmable input 1 |
12 | P2 | Programmable input 2 |
13 | P3 | Programmable input 3 |
14 | P4 | Programmable input 4 |
15 | P5 | Programmable input 5 |
16 | P6 | Programmable input 6 |
17 | P7 | Programmable input 7 |
18 | GND | Ground |
Programming Chart for TC9109
Channel | RX Divided by | TX Divided by |
1 | 3254 | 5393 |
2 | 3256 | 5395 |
.. | .... | .... |
40 | 3342 | 5481 |
NOTES:
1. Spesial divided by 2 circuit in TX mode change Referency Divider output to 2.5kHz steps. The 2139 count upshifts produces a 13MHz VCO witch is then doubled for the direct on-channel TX-frequency.
Example of VCO Determination, Channel 1:
3254 x 5kHz = 16.270MHz (RX-Mode)
5393 x 2.5kHz = 134825MHz (TX-Mode)
(13.4825MHz x 2 = 26.965MHz)
This counter shows the number of hits since the
29th January 2000
Go Back To The Components Page
Go Back To The Main Home
Page
Copyright © The Defpom 1997-2008
https://www.radiomods.co.nz/