Modifications for the Kenwood TW-4000
Kenwood TW-4000 for CAP
On the back of the CPU assembly, (part of the front panel assembly),
there is a wire jumper (sort of a loop of wire between two pads on
the board). If you clip this wire, and reset the CPU, the '4000
will RX-TX from 141.0 Mhz to 150.995 Mhz. There is no change on
UHF.
Keith McQueen, Wicat Systems Inc. , (801)224-6400
Packet: n7hmf @ nv7v.UT.USA.NA
Internet: keithm@wicat.com
Go Back To The Kenwood Mods Page
Go Back To The Main Modifications Page
Go Back To The CB / HAM Radio Main Page
Go Back To The Main Home Page
Copyright © The Defpom 1997-2008
https://www.radiomods.co.nz/