Modifications for the Yaesu FT-10

Modifications for the Yaesu FT-10
Yaesu FT-10 Extended Transmit Mod for 140-174MHz use

Remove antenna and battery.
Locate the Ni-Cd battery sticker on the back of the radio chassis. Pry up the corner of the sticker and peel it off carefully.
Remove the two screws located under the sticker. These retain the keypad.
Slowly lift off the keypad. Use care not to dislodge the gasket.
Locate and unsolder the 0 ohm chip resistor at location "M" (see diagram below).
Re-install keypad with two screws. Be sure gasket is properly seated.
Replace the Ni-Cd sticker if desired. Reattach battery and antenna.
Press down and hold the Top-Notch and Lamp button while turning the radio on.

   | knob |
 +---------------------+
 |  +---------------+  |
 |  |  LCD Display  |  |
 |  |               |  |
 |  +---------------+  |
 |  -----------------  |
 |  -----------------  |
 |  -----------------  |
 | (on/off) ---------  |
 |                     |
 |  +---------------+  |
 |  |    Ribbon     |  |
 |  |    Cable      |  |
 |  |    ||||||     |  |
 |  |  o         o  |  |
 |  |         ::    |  |
 |  |           #:  |  |
 |  +---------------+  |
 +---------------------+

# = Location "M", chip resistor to remove

If memory serves me, the board actually has an "M" near the correct resistor.

This counter shows the number of hits since the 9th February 2000

Go Back To The Yaesu Mods Page

Go Back To The Main Modifications Page

Go Back To The CB / HAM Radio Main Page

Go Back To The Main Home Page

https://www.radiomods.co.nz/