Modifications for the Yaesu FT-76

> Modifications for the Yaesu FT-76 FT-27, 76 expanded frequency range

Remove the screws holding battery track and rear cover.
Locate the "CONTROL UNIT".
Close jumpers 1, 3, 7, AND 8.
Reassemble the radio.
Turn on the radio and program it as following:
"1" 135.000 PRESS D/MR THIS IS LOWER RX LIMIT
"2" 185.000 PRESS D/MR THIS IS UPPER RX LIMIT
"3" 135.000 PRESS D/MR THIS IS LOWER TX LIMIT
"4" 185.000 PRESS D/MR THIS IS UPPER TX LIMIT

Press and hold D/MR, T and REV while TURNING ON if you need to reset or reprogram the radio.

YAESU FT-76 expanded frequency range:

Same as above.
Close jupers 1, 3, 4, 7 AND 8.
Program 420 to 460 mhz as above.

Notes:

Jumper 5 is for 25 KHZ steps default value.
Jumper 9 is for battery back-up.
Jumper 10 is for 1750 HZ repeater tone access.

This counter shows the number of hits since the 9th February 2000

Go Back To The Yaesu Mods Page

Go Back To The Main Modifications Page

Go Back To The CB / HAM Radio Main Page

Go Back To The Main Home Page

https://www.radiomods.co.nz/