The Defpom Forum, for RadioMods, S&M Software and Music by The Defpom

cobra 29 ltd ST 80 channel using pll LC72322N

there is on mob done the problem is the rx is very poor i can receive things close to me but any thing more than 2 miles the receive is very poor

every thing sounds off frequency

i have had my frequency counter on and seems to be ok on tx

i have no ...

thank you for your help

thanks for your help

relay stuck on this one

sorry made a error ment to say vr 203

i have put it flat out still no luck

any other ideas

the radio is using a stock pre driver 2314

could this be changed and it so what could i put in its place

i was also told that i could jumper the resistor from the bac of the final to the pre driver

hi can any one help me

i have a cobra uk 29 ltd st using pll 72322

i have replaced the final with a 1969 and returned L301 L302 L303 AND RV 201 but i can only get 6 watts out of it can any one help what am i doing wrong ??

do i have to disable the sound tracker as it dont work any way

i am ...

Sirio Hypower 4000

i found this to be the best yet hope this helps

thanks for clearing that up rick

can you suggest which final to use

hi i would like to no if i can get more power out of a intek m790 cb at the min it doing 3.5 w on a dead key

is it posable to install a swing kit or put a bigger out put transistor in the cb

any help on this would be a good help to me thanks

hi rick what is the ic number for the af amp thanks for your time

the info on the bord is as follows

cobra gr25/29 ltd st

the pa is working and it lights up ok the tx rx light is working ok

there is no receive
no tx as in no power out put at all

there is 2 bad caps c212 and c218 think it has had 24 volts throw it or reversed power

any one got any ideas ...

thanks rick got the delta force going was a bad final

the cobra is a 148 gtlx dx that is def and no dx thanks for the time

hi the cb is a magnum delta force 10 meter cb that is all no i dont no the pll number any help

[/quote]

bord number jpmxx0276d

delta force magnum am/fm/ssb/pa 10m mobile

got low power less than 1 w damaged due to hi SWR res number 376 22 ohm getting hot tested zener diodes there ok and i have replaced both the c1969 and c2166 out put transistors and still low power

help any one got a clue

ps ...

cobra powers up no tx or rx mic ok any one help

ps its fitted with a conversion of the uk 40 channel

got low power less than 1 w damaged due to hi SWR res number 376 getting hot tested zener diodes there ok and i have replaced both the 1969 and 2166 out put transistors and still low power

help any one got a clue

ps there is also sound coming out of sicker during tx

please excuse the spelling ...