TRC70
Posted: Saturday 16th Aug 2008, 19:10
I have a Kenwood TRC70 and know that via S301, you can set the TX power to Hi, Med or Lo.
Does anyone know of a code via the keypad to do this?
I did try and rig a switch via ribbon cable to S301 but it creates noise on the RX side - I think the wire is picking up something.
Cheers,
Steve.
Does anyone know of a code via the keypad to do this?
I did try and rig a switch via ribbon cable to S301 but it creates noise on the RX side - I think the wire is picking up something.
Cheers,
Steve.