The Defpom Forum, for RadioMods, S&M Software and Music by The Defpom

Hi All,

I've got a Ham Concorde 3 (PTBM133A4X board & PLL 02A) which has in a previous life been converted to work on 10 meters.

I've looked at the Xtals & X6 is missing (no holder either)

X5 = 21.252.5 (I'll change back to 20.330)

X4 = 21.027.5 (I'll change back to 20.105)

X3 = 20.802.5 (I'll change back to 19.880

I suppose X6 was 20.555 ???

Anyway, the question is do I need to disable the lock detector incase the VCO is outside it's limits or does this only apply when doing the mod the other way round, ie 11m to 10m ???

Any assistance (in laymans terms for a knuckle-dragging northerner) greatly appreciated.

Steve

Steve,
Just replace the crystals and adjust the VCO slightly.
20.555 is the super high crystal, I've got a bag full if you need any.

Dave.

Cheers Dave

Any idea where's best to source the others & what load capacitance to I specify - I tried Knights & Truck King & I think Tonks are no longer trading???

I'll have a Super Hi if I can get hold of the others.

Thanks again.
Steve

Anyone?

I'm looking for a source of replacement crystals for the Concorde 3 ???

Thanks in anticipation.

Someone has PM'd me about this - however, when I try to access my Inbox to retrieve the message I get an alert informing me I'm unable to initiate PM's! That's all well & good but I'm just trying to access my Inbox FFS

Anyone got any idea's???

My email addy is steve(dot)woodcock5(at)btinternet(dot)com

Cheers

Steve